A SERVICE OF

logo

Open as PDF
next previous
OSPF Commands 877
enable
Use the enable command in Router OSPF Configuration mode to reset the
default administrative mode of OSPF in the router (active). Use the no form
of the command to disable the administrative mode for OSPF.
Syntax
enable
no enable
Default Configuration
Enabled is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables OSPF router mode.
console(config-router)#enable
exit-overflow-interval
Use the exit-overflow-interval command in Router OSPF Configuration
mode to configure the exit overflow interval for OSPF. When a router leaves
the overflow state it can originate non-default AS-external-LSAs. When set to
0, the router will not leave Overflow State until restarted. Use the no form of
the command to return the interval to the default value.
Syntax
exit-overflow-interval
seconds
no exit-overflow-interval