9
Connecting the appliance
Important!
Check that the mains power supply voltage corresponds to
the value indicated on the rating plate on the bottom of the
appliance.
Connect the appliance to an earthed and correctly installed
socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualied
professional.
Using the appliance for the rst time
Please note!
t $PòFFIBTCFFOVTFEUPGBDUPSZUFTUUIFBQQMJBODFBOEJU
is therefore completely normal for there to be traces of
coee in the mill.
The machine is, however, guaranteed to be new.
t :PVTIPVMEDVTUPNJTFXBUFSIBSEOFTTBTTPPOBTQPTTJCMF
following the instructions in the section “Setting the
water hardness” on page 18.
1. Insert the power cable connector into the socket at the
back of the appliance and connect the appliance to the
mains electricity supply (g. 1). Make sure the main
switch at the back of the appliance is pressed (g. 2).
You must rst choose the language (the languages scroll
through at intervals of about 3 seconds).
2. When “English” appears, press and hold the
button (g. 3) for a few seconds until “English set” is
displayed.
Follow the instructions displayed by the appliance:
3. “FILL TANK!”: remove the water tank (g. 4), ll to the
MAX line with fresh water then replace in the appliance.
4. “INSERT WATER SPOUT!”: Check that the hot water spout
is inserted on the nozzle and place a container with a
minimum capacity of 100 ml underneath (g. 6).
5. “Hot water... Press OK?” is displayed;
6. Press the
button to conrm (g. 3). The
appliance delivers water from the spout then goes o
automatically.
The coee maker is now ready for normal use.
Please note!
t 8IFOVTJOHUIFBQQMJBODFGPSUIFöSTUUJNFZPVOFFEUP
make 4-5 cups of coee or 4-5 cappuccinos before the
appliance starts to give satisfactory results.
t 5PIFMQSFEVDFUIFCVJMEVQPGMJNFTDBMFJOUIFBQQMJBODF
and soften the water taste, we recommend installing a
water lter as described in the section “WATER FILTER”.
If your model is not provided with a lter, you can request
one from De’Longhi Customer Experience.
TURNING THE APPLIANCE ON
Please note!
Before turning the appliance on, make sure the main switch on
the back of the appliance is pressed (g. 2).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this
cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coee spouts
and is collected in the drip tray underneath.
Avoid contact with splashes of water.
t 5PUVSOUIFBQQMJBODFPOQSFTTUIF
button (g. 7).
The message “Heating up... Please wait” is displayed.
After heating, the message “Rinsing...” is displayed. As well as
heating the boiler, the appliance also heats the internal circuits
by circulating hot water.
The appliance has reached the required temperature when a
message is displayed indicating the coee taste and quantity.
TURNING THE APPLIANCE OFF
Each time the appliance is turned o, it performs an automatic
rinse cycle which cannot be interrupted.
Danger of burns!
During rinsing, a little hot water ows from the coee spouts.
Avoid contact with splashes of water.
To turn the appliance o, press the
button (g. 7).
The appliance performs a rinse cycle, then the message
“Turning o underway Please wait...” is displayed and the
appliance goes o.
Please note!
If the appliance is not used for an extended period, switch o
the machine at the main switch (g. 2).
Important!
To avoid damaging the appliance, never switch the appliance
o at the main switch before it has been turned o using the
button.
