16
To remove the drip tray:
1. Remove the drip tray and the grounds container (g. 26);
2. Empty the drip tray and grounds container and wash
them;
3. Check the red condensate tray and empty if necessary.
4. Replace the drip tray and grounds container.
Cleaning the inside of the coee maker
Danger of electric shock!
Before cleaning internal parts, the machine must be turned
o (see “Turning o”) and unplugged from the mains power
supply.
Never immerse the coee maker in water.
1. Check regularly (about once a month) that the inside of
the appliance (accessible after removing the drip tray) is
not dirty. If necessary, remove coee deposits with the
brush provided or a sponge.
2. Remove the residues with a vacuum cleaner (g. 28).
Cleaning the water tank
1.
Clean the water tank (A17) regularly (about once a month
and whenever you replace the water softener lter (if
provided) with a damp cloth and a little mild washing up
liquid.
2. Remove the lter (if present) and rinse with running water.
3. Replace the lter (if provided), ll the tank with fresh water
and replace the tank.
Cleaning the coee spouts
1. Regularly clean the coee spouts with a sponge or cloth
(g. 29A).
2. Check the holes in the coee spout are not blocked.
If necessary, remove coee deposits with a toothpick (g.
29B).
Cleaning the pre-ground coee funnel
Check regularly (about once a month ) that the pre-ground
coee funnel (A6) is not blocked.
If necessary, remove coee deposits with the brush (D2)
supplied.
Cleaning the infuser
The infuser (A9) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned o (see “Turning
the appliance o” on page 9).
2. Remove the water tank.
3. Open the infuser door (g. 30) on the right side.
4. Press the two red release buttons inwards and at the same
time pull the infuser outwards (g. 31).
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap.
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID NO DISH WASHER
Clean the infuser without using washing up liquid as it
could be damaged.
6. Use the brush (D2) to remove any coee residues left in
the infuser housing, visible through the infuser door.
7. After cleaning, replace the infuser by sliding it onto the
internal support; then push the PUSH symbol fully in until
it clicks into place.
infuser support
Please note!
*GUIFJOGVTFSJTEJóDVMUUPJOTFSUCFGPSFJOTFSUJPOBEBQUJUUP
the right size by pressing the two levers shown in the gure.
7. Once inserted, make sure the two red buttons have
snapped out.
PUSH
8. Close the infuser door.
9. Replace the water tank.
Cleaning the milk container
Clean the milk container as described below each time you
prepare milk:
1. Remove the lid.
Large lever
Small lever
