A SERVICE OF

logo

Service Calibrations
5-17
HP DesignJets 1050C and 1055CM Printers Service Manual
3 If you selected to continue, then the following message appears on
the front panel if media is not loaded.
NOTE Make sure that you load E/A0 size HP High Gloss Photo Paper
or HP Coated media. Do NOT use any other type of media apart
from HP Coated or HP High Gloss Photo Paper.
4 The Printer will start to print the calibration pattern and the
following message will be displayed on the front panel:
5 Once the pen to paper spacing calibration is completed, the
following message will be displayed on the front panel:
NOTE Make sure that you press Form Feed and Cut when you have
finished the calibration to trim the calibration pattern from the
media roll.
If the calibration fails, then the following message will appear on
perform this operation
Please, load paper to
and try again
Press ENTER to continue
To p
Enter
Back
Press Enter
through scan axis.
Calibrating pen to pen
Please wait
Press ENTER to continue
To p
Enter
Back
Press Enter
Color to Color
calibrated.