Using the Operator Panel
2-26 ADVANCED OPERATION GUIDE
6
Press U or V repeatedly until >>Quick
Copy appears.
7
Press [OK] ([ENTER]). A blinking cursor (_)
appears.
8
Press U or V to increase or decrease the value at the blinking cursor. The
value can be set between 0 and 50. Use Z and Y to move the cursor right
and left.
9
When the desired maximum number of jobs is set, press [OK] ([ENTER]).
10
Press [MENU]. The display returns to Ready.
Maximum Space Assigned to Temporary Code Jobs
This changes the hard disk space that holds temporary code jobs. You can
change the maximum space from 0 to 9999 (megabytes). The actual
maximum size depends on the size of free hard disk space. The default
size is 1/6 of the total hard disk space, rounded off in units of 50MB. For
example, if the total hard disk space is 10GB, the default size is 1550MB.
1
Press [MENU].
2
Press U or V repeatedly until e-MPS >
appears.
3
Press Z.
4
Press U or V repeatedly until >e-MPS
Configuration > appears.
5
Press Z.
6
Press U or V repeatedly until >>Temp.
Code JOB Size appears.
7
To change the maximum disk space, press
[OK] ([ENTER]). A blinking cursor (_)
appears.
8
Press U or V to increase or decrease, respectively, the value at the
blinking cursor. Use Z and Y to move the cursor right and left.
>>Quick Copy
32
>>Quick Copy
32
e-MPS >
>e-MPS >
Configuration
>>Temp. Code JOB
Size 1550MB
>>Temp. Code JOB
Size 1550
MB
