Using the Operator Panel
2-34 ADVANCED OPERATION GUIDE
2
Enter the submenu by pressing Z. Each
time you press U or V, the selection
changes.
3
When >>IP Address is displayed, press
[OK] ([ENTER]). A blinking cursor (_)
appears at the last digit.
4
Press U or V to increase or decrease, respectively, the value at the
blinking cursor. Use Z and Y to move the cursor right and left.
5
When the IP address is entered, press [OK] ([ENTER]).
6
Press U or V to move to Subnet Mask. Perform the same procedure to
complete entering the subnet mask address.
7
Then, press U or V to move to Gateway. Perform the same procedure to
complete entering the gateway address.
8
Press [MENU]. The display returns to Ready. You can print a network
status page to confirm that the IP address, subnet mask address, and the
gateway address have been properly set. To print a network status page,
see Printing a Network Interface Status Page on page 2-35.
>>IP Address
000.000.000.000
>>Subnet Mask
000.000.000.000
>>Gateway
000.000.000.000
>>BOOTP
Off
>>DHCP
Off
>>IP Address
000.000.000.000
