NOTE:
Autolight activation sensitivity and the
time delay for autolight shutoff is adjust-
able for vehicles with color display screen.
See “Vehicle electronic systems” in the
“Display screen, heater, air conditioner,au-
dio and phonesystems”section laterin this
manual.
To turn on the autolight system:
1. Turn the headlight switch to the AUTO posi-
tion
᭺
1
.
2. Place the ignition switch in the ON position.
3. The autolight system automatically turns the
headlights on and off.
Initially, if the ignition switch is placed in the OFF
position and a door is opened and left open, the
headlights remain on for 5 minutes. During that 5
minutes:
● if all doors are closed, the headlights remain
on for 45 seconds, then turn off.
● if another door is opened, then the 5 minute
timer is reset.
To turnthe autolight system off, turn the switch to
the OFF,
,or position.
Be sure you do not put anything on top of
the autolight sensor
᭺
1
located on top of
the instrument panel. The autolight sensor
controls the autolight; if it is covered, the
autolight sensor reacts as if it is dark out
and the headlights will illuminate. If this
occurs while parked with the engine off
and the ignition switch is placed in the ON
position, your vehicle’s battery could be-
come discharged.
Headlight beam select
᭺
1
To select the high beam function, push the
lever forward. The high beam lights come on
and the light illuminates.
᭺
2
Pull the lever back to select the low beam.
᭺
3
Pulling and releasing the lever flashes the
headlight high beams on and off.
Battery saver system
If the ignition switch isplaced in the OFF position
while the headlight switch is in the
or position,the headlights will turn off after
5 minutes.
LIC0954 LIC0390
2-20 Instruments and controls
੬ REVIEW COPY—
2009 Quest (van)
Owners Manual—USA_English (nna)
07/17/08—debbie
੭
