A SERVICE OF

logo

Open as PDF
next previous
Check the tightness of the tie-down cleat peri-
odically during a trip tomake sure the center bolt
has not become loose.
Install the tie-down cleat as follows:
1. Remove the channel protectors by sliding
them out the back of the truck bed. Properly
store the channel protectors.
2. Loosen the center bolt completely.
3. Insert thecleat intothe channel perpendicu-
lar to the channel as shown. Then rotate the
cleat clockwise 90° and slide it to the de-
sired location.
4. Position the cleat sothe nubs on thebottom
fully seat into the channel detents.
LTI0103
LTI0104
Technical and consumer information 9-17