57
Connection Using i.LINK
Chapter 5 Connections and Settings for Editing
• During audio editing, make sure that the base tape (the
tape to be edited) recording mode and the DSR-2000A/
2000AP audio recording mode are the same. If the audio
modes are different, an alarm is displayed, and editing is
disabled.
• For linear editing using i.LINK input, if controlled
through the RS-422A interface, the edit points may be
offset, and the precision reduced. Use the i.LINK
interface also for control.
For details of DSR-2000A/2000AP settings, refer to the
DSR-2000A/2000AP Operating Instructions.
Notes
REMOTE
AC IN
1/3 2/4
AUDI O
IN
VIDEO
IN
Y/S-Y/CPST R-Y/S-C B-Y
REF.VIDEO VIDEO OUT
MONITOR
AUDIO
IN(SD/HD)
IN OUT1 OUT2
Y/CPST
IN
INTC OUT
1/2 3/4 1/2 3/4
OUTAUDIO I/O (AES/EBU)
(SUPER)
CPST
SDI
OUT1 OUT2
HD-SDI
HDV/DV
AUDI O
OUT
1/3 2/4
Pr/R-Y/S-C
Pb/B-Y/S-Y
VIDEO OUT
(SUPER) CPST
MONITOR
AUDIO
i.LINK
MONITOR
AUDIO
VIDEO OUT 3
(SUPER)
HDV/DV
SD monitor
2Pin plug cable (not supplied)
175 Ω coaxial cable (not supplied)
3i.LINK cable (not supplied)
Audio input
Composite video input
HVR-1500
(this unit, player)
DSR-2000A/2000AP (recorder)
Composite video input
Audio input
SD monitor
1
2
3
1
2
DSR-2000A/2000AP
(recorder) settings
Settings on this unit
INPUT SELECT menu item:
i.LINK
Remote control switch:
i.LINK
Remote control setting
section: i.LINK button (lit)
