Chapter
6
64
Digital Dubbing
Chapter 6 Using the i.LINK Connector for Dubbing and TC Insert
Using the i.LINK Connector
for Dubbing and TC Insert
Digital Dubbing
In addition to straightforward tape dubbing, you can also
use this unit to dub signals in HDV 1080i or DVCAM/DV
format automatically from the beginning of the tape to the
end through the i.LINK interface.
Connections and Settings
The following figure shows an example of the connections
for carrying out dubbing through the i.LINK interface,
using this unit as the recorder, and an HVR-Z1 as the
player.
1) The i.LINK output format must be set.
For details of the HVR-Z1 settings, refer to the HVR-Z1
Operating Instructions.
HVR-Z1 (player) setting
Settings on this unit
VCR HDV/DV in the (IN/
OUT REC) menu
1)
: HDV or
DV
Press the i.LINK button in the
video/audio input selection
section, to display i.LINK:DV,
i.LINK:DVCAM or i.LINK:HDV
in the input signal display
REMOTE
AC IN
1/3 2/4
AUDI O
IN
VIDEO
IN
Y/S-Y/CPST R-Y/S-C B-Y
REF.VIDEO VIDEO OUT
MONITOR
AUDIO
IN(SD/HD)
IN OUT1 OUT2
Y/CPST
IN
INTC OUT
1/2 3/4 1/2 3/4
OUTAUDIO I/O (AES/EBU)
(SUPER)
CPST
SDI
OUT1 OUT2
HD-SDI
HDV/DV
AUDI O
OUT
1/3 2/4
Pr/R-Y/S-C
Pb/B-Y/S-Y
HDV/DV
HDV/DV
HVR-Z1 (player)
HVR-1500 (this unit, recorder)
(6-pin)
i.LINK cable (not supplied)
(4-pin)
