Rx100 installation manual V1.17 29 Aug 08.doc Page 28
BBV Rx100 & Rx100/24
Addendum to manual for the following domes:
Samsung SCC-641 Interface
Rx100 software RX1_S5V3
Application Notes
The Rx100 allows control of the following dome features: Variable speed Pan/Tilt, Zoom/Focus/Iris, 16 full scene presets,
2 preset patrols, 4 alarm inputs driving to preset 1 – 4, Dome Pattern 1 playback using the AUTOPAN key ,Menu Access
Advanced Features BBV Tx1000 BBV Tx400 DM Sprite DS/DSL
Display Menu (Twice) '#' WASH '#' 1 *889 002 *889 10 10 2
Turn Menu Off '#' WIPE '#' 2 *889 003 *889 10 10 3
ENTER within menu '#' AUTOPAN '#' 3 *889 004 *889 10 10 4
Dome FACTORY RESET '#' LIGHTS '#' 4 *889 005 *889 10 10 5
RS485 control of dome. Data rate link selectable using J6/1-2. Fitted = 9600,N,8,1 and removed = 19200,N,8,1
Connection details:
Dome RX100
RX- J3/C1
RX+ J3/C2
Notes:
J6/pin 1-2 is used to select the baud rate to drive the dome, either 9600 or 19200 baud.
Fitted(Default) = 9600,N,8,1 Removed = 19200,N,8,1(used if experience run on problems with 20mA telemetry)
The dome’s SW500 and SW501 switches must be set as follows:
SW500 sets the dome’s address to 01. 1 = ON, 2,3,4,5,6,7,8 = OFF
SW501 is used to set the dome’s RS485 baud rate, Termination and protocol selection.
For 9600 baud set as follows: 1,2,3,5 = ON 4,6,7,8 = OFF
For 19200 baud set as follows: 1,2,3,4 = ON 5,6,7,8 = OFF
Menu Access when using a BBV Tx1000DC
Display Menu: Press and HOLD # and tap WASH TWICE
will display the dome’s menu.
Use the joystick to navigate the cursor and HOLD # and tap AUTOPAN as ENTER.
Turn Menu Off: Press and HOLD # and tap WIPE
Dome FACTORY RESET: Press and HOLD # and tap LIGHTS THREE
times to return the dome to factory defaults.
Menu Access when using a BBV Tx400DC
Display Menu: Press and HOLD # and tap 1 TWICE
will display the dome’s menu.
Use the joystick to navigate the cursor and HOLD # and tap 3 as ENTER.
Turn Menu Off: Press and HOLD # and tap 2
Dome FACTORY RESET: Press and HOLD # and tap 4 THREE
times to return the dome to factory defaults.
Menu Access when using DM DS/DSL/DS2
Display Menu: *889 10 10 2 TWICE
will display the dome’s menu.
Use the joystick to navigate the cursor and *889 10 10 4 as ENTER.
Turn Menu Off: *889 10 10 3
Dome FACTORY RESET: *889 10 10 5 THREE
times to return the dome to factory defaults.
CAUTION – READ BEFORE PERFORMING A DOME FACTORY RESET!
USE WITH EXTREME CARE AS ALL THE DOME PROGRAMMING INCLUDING PRESET POSITIONS WILL BE
LOST.
