Rx100 installation manual V1.17 29 Aug 08.doc Page 31
Rx 100 Interface Receiver
Addendum to manual for the following domes:
Chugai SMD-08II, SMD-12, SMD-12II, SMD-20
Sanyo VCC-9200P
Star MD-800, MD-1200S, MD-1200H, MD-2000
Rx100 software RX1_S2V6
Application Notes
The RX 100 provide the following functionality when controlling the above mentioned domes
Variable speed Pan/Tilt, from 0.8deg/sec to 120deg/sec.
Zoom/Focus, Autofocus following a Zoom In/Out.
(Autofocus enabled with link fitted on J6 pin 1&2)
16 Full scene presets.
2 preset patrols.
4 alarm inputs.
Additional commands:
AUTOPAN: Pressing the AUTOPAN key will run the domes in-built swing feature. Preset positions 1 & 8 must be
programmed before the swing is started. Preset 1 is the right hand stop, preset 8 is the left hand stop. Tilt and lens can be
adjusted whilst the dome is swinging.
180deg PAN AUTO FLIP is accomplished by pressing either '#'WASH on Tx1000 or '#'1 on Tx400.
DOME REMOTE RESET can be started by pressing either '#'LIGHTS on Tx1000 or '#'4 on Tx400.
RS485 control of dome using the following connections:
Rx100 Description Dome mounting bracket
J3-C1 TX/RX- Data- Pin 2
J3-C2 TX/RX+ Data+ Pin 1
Notes:
The alarm output relay opens for approx 2 seconds upon power up. This can be used to signal power loss, etc.
When programming a preset position, control is prohibited until the dome has stored the position into it's eeprom memory, approx 1-2 seconds.
Following a goto preset command, all further commands are ignored until the dome has reached it's preset position including any alarm input.
If swing is running, start patrol 1 & 2 is inhibited. The dome will be driven to a preset following an alarm activation. 60 seconds after alarm, swing will restart.
If a manual goto preset is pressed, the dome will stop swinging and move to the preset position. The AUTOPAN led will be on until the next manual pan
command.
