13
English
5. Set up
■ MOUNTING ENGINE (SE1)
1. Push the driveshaft housing
toward the clutch housing and
rotate it by hand to check that the
driveshaft is engaged with the
gears.
2. Insert the driveshaft housing into
the clutch housing until it bottoms,
and align the positioning holes on
the both housings and install the
screw.
3. Fasten the clamp securely with 2
screws.
■ CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle
wire to the joint on the top of the
carburetor. (SE2)
■ CONNECTING SWITCH WIRES
(SE3)
• Connect the switch wires between
the engine and the main unit.
• Fix the switch wire like figure of
SE3.
• The space between a tank and
switch wires is 3mm or more.
(1) 3mm or more
■ INSTALLING HANDLE (SE4)
• Install the handle to the shaft tube
and clamp it at a location that is
comfortable to you.
(1) About 48cm
■ JOINT ATTACHMENT (SE5)
• Insert the attachment to the main
shaft.
• Tighten the knob bolt securely.
(1) Knob bolt
SE1
SE2
SE3
SE4
