14
English
5. Set up
■ ATTACHING THE PRUNING
MECHANISM (SE6)
1. Remove the cap on the end of the
main pipe.
2. Remove the screw screwed into
the end of the gear case.
3. Insert the end of the gear case into
the main pipe.
4. Line up the hole on the end of the
gear case into which the screw is
to be inserted with the hole on the
main pipe, and screw the screw
firmly in.
5. Using a wrench, screw in the bolt
provided to fix the mechanism into
place.
(1) Main pipe (2) Gear case
(3) Screw hole (4)Fastening bolt
(5) Bolt
A standard package contains the
items as shown below. (SE7)
(1) Guide bar (2) Saw chain
(3) Gear case (4) Sprocket
(5) Chain tension adjust screw
(6)
Nut
(7)
Chain tensioner nut
(8) Chain
cover
Install the guide bar and the saw
chain on the gear case as follows.
The saw chain has very sharp
edges. Use protective gloves for
safety.
1. Loosen a nut and remove the
chain cover.
2. Mount the guide bar then fit the
saw chain around the bar and
sprocket.(SE8)
Pay attention to the correct
direction of the saw chain
