8
English
hand can comfortably hold the
handlebar grip approximately waist
high.
■ STARTING THE ENGINE
1. Keep bystanders and animals at
least 15 m away from the
operating point. If you are
approached, immediately stop the
engine.
2. The product is equipped with a
centrifugal clutch mechanism, so
the cutting attachment begins to
rotate as soon as the engine is
started by putting the throttle into
the start position. When starting
the engine, place the product onto
the ground in a flat clear area and
hold it firmly in place so as to
ensure that neither the cutting part
nor the throttle come into contact
with any obstacle when the engine
starts.
Never place the throttle into the
high speed position when starting
the engine.
3. After starting the engine, check to
make sure that the cutting
attachment stops rotating when
the throttle is moved fully back to
its original position. If it continues
to rotate even after the throttle has
been moved fully back, turn off the
engine and take the unit to your
authorized Zenoah servicing
dealer for repair.
■ USING THE PRODUCT
Cut only materials recommended
by the manufacturer. And use only
for tasks explained in the manual.
1. Grip the handles firmly with both
hands using your whole hand.
Place your feet slightly apart
(slightly further apart than the
width of your shoulders) so that
your weight is distributed evenly
across both legs, and always be
sure to maintain a steady, even
posture while working.
2. Maintain the speed of the engine
at the level required to perform
cutting work, and never raise the
