Chapter 4 Network Setting
NWA1300-NJ User’s Guide
33
4.3 LINK
Use this screen to change your IP settings. The NWA1300-NJ’s Ethernet port is set
to DHCP client mode by default. Click NETWORK SETTING > LINK.
Figure 6 NETWORK SETTING > LINK
The following table describes the labels in this screen.
Table 4 NETWORK SETTING > LINK
LABEL DESCRIPTION
DHCP Client Select this option if your NWA1300-NJ is using a dynamically assigned
IP address from a DHCP server each time.
Note: You must know the IP address assigned to the NWA1300-
NJ (by the DHCP server) to access the NWA1300-NJ again.
MTU Setting Enter the MTU (Maximum Transmission Unit) size for the Ethernet
interface.
Static IP Select this option if you were assigned a fixed IP address (and DNS
server settings) to use for Internet access
IP Address Enter the IP address of your NWA1300-NJ in dotted decimal notation.
Note: If you change the NWA1300-NJ's IP address, you must use
the new IP address if you want to access the web
configurator again.
Subnet Mask Enter the subnet mask that specifies the network number portion of an
IP address.
