CALIBRATION AND SETUP, CONT.
7. CLEAR ID=XXX (CLEAR ID)
W er will be
s ed
to
CLR ID= NO
8. NO OF SCALES=X (NUMBER OF SCALES)
With SETUP MENU #1 displayed the current setting for the parameter
lue. If the setting displayed is acceptable,
d then using the numeric keys, enter the
ER key to save the new setting and return to
ed for number of scales, the 225 will check for additional
9. TOTALIZE=XXX (SCALE TOTALIZER)
With t ard installed an f scales set for 2 or 3, the 225
can sum s and displayed.
The totalizer can be referenced as if it were another scale. NOTE! The totalizer's scale
e actual number of scales attached to the indicator.
he current value. If the setting displayed is acceptable,
roceed to the next setup parameter.
eys) and then the
NTE and return to SETUP MENU #1.
TOTALIZE=YES TOTALIZE=NO
S
tical settings for:
, DDP, SAMPLES, STABLE
DE
ed.
ith SETUP MENU #1 displayed the current setting for the CLEAR ID= paramet
hown. Note that XXX is the current value. If the setting displayed is acceptable, proce
the next setup parameter.
Otherwise, press the 7 key, the ENTER key, YES or NO (on the soft keys) and then the
ENTER key to save the new setting and return to SETUP MENU #1.
CLR ID=YES
Automatically clears ID after print ID is not cleared after print
NO OF SCALES=
will be shown. Note that X is the current va
proceed to the next setup parameter.
therwise, press the 8 key, the ENTER key anO
number of scales and then press the ENT
SETUP MENU #1. Allowable values are: 1, 2 or 3.
NOTE! Support for more than 1 scale requires the 225-DS (Dual Scale) Card.
If 2 or 3 are enter
scales. If additional scales are not found, it will display an error message and
default back to 1 scale.
he 225-DS (Dual Scale) C d the number o
the weights of two or more scale make the total available to be
number will always be 4 regardless of th
With SETUP MENU #1 displayed the current setting for the TOTALIZE= parameter will
be shown. Note that XXX is t
p
Otherwise, press the 9 key, the ENTER key, YES or NO (on the soft k
E R key to save the new setting
Scale Totalizer Enabled cale Totalizer Disabled
NOTE! All scales to be included in the totalizer must have iden
BASE UNITS, CNVT UNITS, INTERVAL
and STBL CNT. They also must be set for WT INTERVALS=1 and MO
OF OP=0 1 , an error message will be display or . If these are not the same
8200-M538-O1 y 225 Installation
Page 38
