CALIBRATION AND SETUP, CONT.
2. PRT BEG=XXXXXXXXXXXX (PRINT BEGINNING)
ll be shown. Note that XXXXXXXXXXXX is the string of HEX numbers
sent to the printer before anything else. If the setting displayed is acceptable, proceed
to the next setup parameter.
Otherwise, press the 2 key, the ENTER key and then using the alphanumeric keys,
enter the new string and then press the ENTER key to save the new setting and return
to PRI
3. AUTO AT TERMINATION”)
With PRINT TABBING MENU #1 displayed the current setting for the AUTO LF=
parameter will be shown. Note that XXX is the current value. If the setting displayed is
ameter.
setting and return to PRINT TABBING MENU #1.
4. ENDING LF=XX ST LINE)
With P NDING LF=
param d commands
that th r, to space the
paper rint. If the
setting
Otherwise, press the 4 key, the ENTER key and then using the numeric keys, enter the
value for the number of linefeeds to be exec
PRINT TABBING MENU #1.
5.
s the key and then using the alp
enter the new string and then press the E save th g and return
to PRINT TABBING MENU #1.
1
HEX numbers are always 2 digits. For example, 7 is entered as 07. The maximum
entry is 6 numbers (12 characters). Valid entries are 01 through FF. Note that 00 is not
valid.
With PRINT TABBING MENU #1 displayed the current setting for the PRT BEG=
parameter wi
1
NT TABBING MENU #1.
LF=XXX (AUTOMATIC LINE FEED “DATA FORM
acceptable, proceed to the next setup par
Otherwise, press the 3 key, the ENTER key, YES or NO (on the soft keys) and then the
ENTER key to save the new
(N AFTER LAUMBER OF LINEFEEDS PRINTED
RINT TABBING MENU #1 displayed the current setting for the E
eter will be shown. Note that XX is a pre-selected number of linefee
ee indicator can transmit at the end of a data transmission to a print
in the printer to the desired position for withdrawal or for the next p
displayed is acceptable, proceed to the next setup parameter.
uted after the last printed line and then
press the ENTER key to save the new setting and return to
Allowable values are: 0 through 99.
PRT END=XXXXXXXXXXXX (PRINT BEGINNING)
With PRINT TABBING MENU #1 displayed the current setting for the PRT END=
parameter will be shown. Note that XXXXXXXXXXXX is the string of HEX numbers
1
sent to the printer after the ENDING LF. If the setting displayed is acceptable, proceed
to the next setup parameter.
Otherwise, pres 5 key, the ENTER hanumeric keys,
e new settinNTER key to
8200-M538-O1 y 225 Installation
Page 50
