ID STORAGE SETUP
Mode of Operation = 1 (ID Storage)
With SETUP MENU #1 displayed the current setting for the MODE OF OP= parameter wil
be shown. Press the 1 and 0 keys and then the ENTER key. The display will change to sho
the Mode Of Operation Menu. Press the 1 key and then the ENTER key to select
ID Storage. The display will change to show the ID Storage Menu.
l
w
ID Storage Menu
1. WT ALARM=XXX 3. PROMPT 1=XXXXXXXXXXXX
2. ID COUNT=X 4. PROMPT 2=XXXXXXXXXXXX
5. PROMPT 3=XXXXXXXXXXXX
Enter Selection: 0 ^ EXIT
¿
1. WT A
With the ID Storage Menu displayed the current setting for the WT ALARM=
parameter will be shown. Note that XXX is the current value. The WT ALARM will
energi n the scale exceeds a threshold
weight. If the setting displayed is acceptable, proceed to the next setup parameter.
S or NO (on the soft keys) and then the
ALARM = NO
Weight Alarm is ON Alarm is OFF
2. ID COUNT
With th g for the ID COUNT=
param lue. These categories will be
displayed when the ID key is pressed. Fo
trailer, displayed is
accep
Otherwise, press the 2 key, the key and then using the numeric keys, enter the
ey to save the new setting
ID COUNT=1 ID COUNT=2 ID COUNT=3
rompts
he value selected for will determine the number of additional prompts
¿
LARM (WEIGHT ALARM)
ze relay #1 for a selected time when the weight o
Otherwise, press the 1 key, the ENTER key, YE
ENTER key to save the new setting and return to the ID Storage Menu.
WT ALARM = YES WT
Weight
(NUMBER OF ID PROMPTS, Categories)
e ID Storage Menu displayed the current settin
eter will be shown. Note that X is the current va
r example, in order to track the truck and
two prompts (categories) would be needed. If the setting
table, proceed to the next setup parameter.
ENTER
value for the printer parity rate and then press the ENTER k
and return to the ID Storage Menu. Allowable values are: 1, 2 or 3.
One Prompt Two Prompts Three P
T ID COUNT
(PROMPT X=) displayed on the ID Storage Menu.
8200-M538-O1 y 225 Installation
Page 76
