A SERVICE OF

logo

*XXXXXXXXX*
*XXXXXXXXX*
6. Rotate the drive bay assembly back to the normal position.
7. To complete the installation, go to “Closing the cover and connecting cables”
on page 113.
Removing and replacing the battery
1. Open the cover. See “Removing the cover” on page 92.
2. Rotate the drive bay assembly upward to gain access to the system board.
3. Refer to “Identifying parts on the system board” on page 95 and locate the
battery.
4. Remove the old battery.
5. Install the new battery.
6. To complete the installation, go to “Closing the cover and connecting cables”
on page 113.
Note: When the computer is turned on for the first time after battery
replacement, an error message might be displayed. The Setup Utility will
start automatically. This is normal after replacing the battery.
98 Hardware Maintenance Manual