A SERVICE OF

logo

2. Clear any cables that might impede the replacement of the cover.
3. Position the cover on the chassis so that the rail guides on the bottom of the
cover engage the rails and push the cover closed until it latches.
4. Reconnect the external cables and the power cord to the computer. See
“Locating connectors on the rear of the computer” on page 116.
5. Turn on the computer. To update the configuration, see Chapter 6, “Using the
Setup Utility,” on page 55.
6. If you have replaced the system board, you must update (flash) the BIOS. See
“Flash update procedures” on page 338.
136 Hardware Maintenance Manual