Using the MPC Chapter 4
MPC User Manual Rev 0D 37
Change the DIRECT row status to CONNECT:YES. Once you have pressed the ENTER key, the
MPC will attempt to ‘dial in’ to the host computer. If successful, the IP address will appear in the
DSTATUS row if there are no errors, and an error message will appear if there is an error.
Open your internet browser and type in the IP address shown in the DSTATUS row as the URL.
If successful, you should see the loading screen as shown in Figure 30.
Figure 30: Loading Screen
This is followed by the Log In dialog as shown in Figure 31.
Figure 31: Website Password
At this point, you can use the preconfigured Administrator User Name and Password to ‘log on’ to the
Modulated Precision Clock website:
User Name: Administrator
Password: Administrator
If you are successfully logged on to the Modulated Precision Clock website, you should see its home
page, see Figure 43, Modulated Precision Clock Home Page on Page 49.
We recommend that you change the Administrator Password to protect your MPC from unwanted
access. If you forget your Administrator Password, you can set up a new Client User Name and
Password through the VFD CONFIG CLIENT menu, see Section 5.2.3, Configure Client on Page 45
and Figure 32 on Page 38, and toggle the ADMIN row to YES.
