Problem Solving Network Problem Solving
112
Network Protocol Setup Messages
The following table lists the network protocol messages that you may see
during the Network Protocol setup. It also contains the last Setup screen
shown before the message appeared, a description of the problem, and any
action required.
Message Setup Screen Description and Action
NO APPLETALK
ZONE FOUND.
ENABLE APPLETALK
(NETWORK
PROTOCOL SETUP>
APPLETALK SETUP)
• The Ethernet network cable
is not attached to the
connector on the DP-C106 or
the network cable is not
plugged into the Hub or
Network. If your AppleTalk
network has zones, and you
want to specify a zone for the
Printer, you must connect the
network cable to the DP-
C106 before performing
AppleTalk Setup.
• AppleTalk network does not
have zones. Zones are not
required for printing to the
DP-C106. Press OK to
continue.
YOU MUST FIRST
ENABLE A
NETWORK PORT.
PROTOCOL SETUP
OR SERVICE SETUP
(NETWORK SETUP)
Enable at least one Network
Port (Ethernet) in Port Setup
before beginning Protocol
Setup or Service Setup.
INVALID FRAME
SIZE
FRAME TYPE
SELECTION
(NETWORK
PROTOCOL SETUP>
IPX>SPX SETUP)
The network hub is not
connected to a Novell server
when the DP-C106 tries to
bind.
WARNING IPX
NETWORK
NUMBER IS ZERO.
FRAME TYPE
SELECTION
(NETWORK
PROTOCOL SETUP>
IPX>SPX SETUP)
No other IPX computer can be
found on the network, or the
network hub is not connected
to the network when the DP-
C106 tries to bind. When this
occurs, the network number
defaults to zero.
