Copy Features
28
Loading Transparencies into the Bypass Tray
Transparencies can be fed only from the Bypass Tray or optional
Transparency Tray that goes into Tray 1 position.
CAUTION
Do not use White-Framed Transparencies in this unit. To prevent the white
tape(s) from jamming inside the Fuser Unit, this machine is designed with a
White-Frame Detection Sensor. Upon detecting the White-Frame of the
Transparency, the unit stops feeding, causes a Jam Indication and the
Printer Screen displays: “WRONG OHP TYPE INSTALLED".
Leaving transparencies in the Bypass Tray can cause static build up, which
can cause a jam. Be sure to remove the transparencies when the job is
complete.
Use the following procedure to load transparencies into the Bypass Tray:
1. Fan the transparency sheets a few at a time to separate them and
prevent static.
2. Insert transparencies into the Bypass Tray until they are touching the
feeding slot. Slide the right-hand Paper Guide against the transparency
stack.
0302514A-WOL
