Operation
30 800092-01 Rev. A www.wegener.com
Figure 3.20: iPump 562 OSD Date/Time Setup
Use the Date/Time Setup screen to set and display the date and time information.
Table 3.13: Date and Time Information Settings
Set Unit Label
Use following steps to display Unit Label Setup screen on the OSD menu:
1. Navigate to the Unit Setup screen, see Unit Setup screen on page 23.
2. Press the down arrow button to select Unit Label.
3. Press Enter.
4. When the six-character label is selected, use the up/down and left/right buttons to set
to a desired label. Press
Enter to save the change. Use the left arrow button to go to
the previous menu level.
Switch Application (to different software version)
Use following steps to display Application Switch screen on the OSD menu:
1. Navigate to the Unit Setup screen, see Unit Setup screen on page 23.
2. Press the down arrow button to select Switch Application.
3. View the details as shown in Figure 3.21.
4. Use the Application Switch to run a backup version of the software on the unit. Upon
selecting the Backup Software by pressing
Enter, the system restarts with the
different software which is labeled as current. The previously run software is labeled
Option Possible values
Current Date Yyyy/mm/dd
Current Time Hh:mm:ss
Time zone All available…
DST Yes / No
