ES-2108 Series User’s Guide
204 Chapter 30 Introducing Commands
30.11.4 interface port-channel Commands
The following table lists the interface port-channel commands in configuration mode.
Use these commands to configure the ports.
dscp <0-63> priority <0-7>
Maps DSCP value with an
802.1p value.
13
list>
Enables PoE (Power over
Ethernet) on the specified
ports.
13
usagethreshold
<1-99>
Sets the percentage of power
usage which initiates mib
traps.
13
mibtrap
Enables mib traps on the
switch. Traps are initiated
when the usage reaches the
limit set up by the
usagethreshold
command.
13
Table 74 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION
PRIVILEG
E
Table 75 interface port-channel Commands
COMMAND DESCRIPTION PRIVILEGE
interface
port-
channel
<port-
list>
Enables a port or a list of ports for
configuration.
13
egress set
<port-list>
Sets the outgoing traffic port list for a port-
based VLAN.
13
igmp-
immediate-
leave
Enables IGMP immediate leave on the
port.
13
igmp-filtering
profile <name>
Sets the IGMP filtering profile for this port. 13
igmp-group-
limited
Limits the number of multicast groups. 13
igmp-group-
limited number
<number>
Sets the number of multicast groups this
port is allowed to join.
13
igmp-querier-
mode
<auto|fixed|ed
ge>
Sets the IGMP querier mode of a port.
Selects
auto to treat the IGMP queries
normally,
fixed to always treat the port
as a querier port no matter there is a
query or
edge to treat the port as a non-
querier port which drops any IGMP
queries received.
13
