GS1920 Series User’s Guide 59
CHAPTER 8
Basic Setting
8.1 Overview
This chapter describes how to configure the System Info, General Setup, Switch Setup, IP
Setup, Port Setup, PoE, Interface Setup and IPv6 screens.
8.1.1 What You Can Do
•Use the System Info screen (Section 8.9 on page 72) to check the firmware version number.
•Use the General Setup screen (Section 8.3 on page 61) to configure general settings such as
the system name and time.
•Use the Switch Setup screen (Section 8.5 on page 64) to choose your VLAN type, set the GARP
timers and assign priorities to queues.
•Use the IP Setup screen (Section 8.6.1 on page 65) to configure the Switch IP address, default
gateway device, the default domain name server and the management VLAN ID.
•Use the Port Setup screen (Section 8.7 on page 67) to configure Switch port settings.
•Use the PoE Status screens (Section 8.8.1 on page 71) to view the current amount of power
that PDs are receiving from the Switch and set the priority levels for the Switch in distributing
power to PDs. This screen is available for PoE model(s) only.
•Use the Interface Setup screens (Section 8.9 on page 72) to configure Switch interface type
and interface ID settings.
•Use the IPv6 screens (Section 8.9 on page 72) to view IPv6 status and IPv6 configuration.
8.2 System Information
In the navigation panel, click Basic Setting > System Info to display the screen as shown. You
can check the firmware version number.
