Chapter 31 DHCP
GS2200-24 User’s Guide
266
Note: You must set up a management IP address for each VLAN that you want to
configure DHCP settings for on the Switch.
See Section 8.7 on page 78 for information on how to set up management IP
addresses for VLANs.
Figure 134 IP Application > DHCP > VLAN
The following table describes the labels in this screen.
Table 86 IP Application > DHCP > VLAN
LABEL DESCRIPTION
VID Enter the ID number of the VLAN to which these DHCP settings apply.
Remote
DHCP Server
1 .. 3
Enter the IP address of a DHCP server in dotted decimal notation.
Relay Agent
Information
Select the Option 82 check box to have the Switch add information (slot
number, port number and VLAN ID) to client DHCP requests that it relays
to a DHCP server.
Information This read-only field displays the system name you configure in the
General Setup screen.
Select the check box for the Switch to add the system name to the client
DHCP requests that it relays to a DHCP server.
Add Click Add to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click this to clear the fields above.
VID This field displays the ID number of the VLAN group to which this DHCP
settings apply.
