Chapter 32 Maintenance
GS2200-24 User’s Guide
273
3 In the web configurator, click the Save button in the top of the screen to make
the changes take effect. If you want to access the Switch web configurator again,
you may need to change the IP address of your computer to be in the same
subnet as that of the default Switch IP address (192.168.1.1).
32.3.2 Save Configuration
Click Config 1 to save the current configuration settings permanently to
Configuration 1 on the Switch.
Click Config 2 to save the current configuration settings to Configuration 2 on
the Switch.
Alternatively, click Save on the top right-hand corner in any screen to save the
configuration changes to the current configuration.
Note: Clicking the Apply or Add button does NOT save the changes permanently. All
unsaved changes are erased after you reboot the Switch.
32.3.3 Reboot System
Reboot System allows you to restart the Switch without physically turning the
power off. It also allows you to load configuration one (Config 1) or configuration
two (Config 2) when you reboot. Follow the steps below to reboot the Switch.
1 In the Maintenance screen, click the Config 1 button next to Reboot System to
reboot and load configuration one. The following screen displays.
Figure 139 Reboot System: Confirmation
2 Click OK again and then wait for the Switch to restart. This takes up to two
minutes. This does not affect the Switch’s configuration.
Click Config 2 and follow steps 1 to 2 to reboot and load configuration two on the
Switch.
