Chapter 24 Maintenance
GS-3012/GS-3012F User’s Guide
168
24.2 Load Factory Defaults
Press the Click Here button next to Load Factory Defaults to clear all switch configuration
information you configured and return to the factory defaults. The following message appears.
Figure 87 Confirm Load Factory Defaults
Click OK to the confirmation screen and go to the next screen.
Figure 88 Close Browser after Load Factory Defaults
Click Yes to close this window. Open a new browser window to access the switch web
configurator again. You may need to change the IP address of your computer to be in the same
subnet as that of the default switch IP address (192.168.1.1).
24.3 Save Configuration
Click Config 1 to save the current configuration settings permanently to Configuration 1 on
the switch.
Click Config 2 to save the current configuration settings to Configuration 2 on the switch.
Save
Configuration
Click Config 1 to save the current configuration settings to Configuration 1 on the
switch.
Click Config 2 to save the current configuration settings to Configuration 2 on the
switch.
Reboot
System
Click Config 1 to reboot the system and load Configuration 1 on the switch.
Click Config 2 to reboot the system and load Configuration 2 on the switch.
Note: Make sure to click the Save button in any screen to save your
settings to the current configuration on the switch.
Table 59 Maintenance (continued)
LABEL DESCRIPTION
