Chapter 11. Dial Plan
61200305L1-1 ATLAS 550 User Manual 11-7
point originated the call. S
RC
ID may be entered with the usual wild card
entries (except $).
The default ID for all Source endpoints and all accept numbers is 0. This
results in all calls being routed based on the dialed number.
A
CCEPT
N
UMBER
Write security: 3; Read security: 5
Designates which numbers this endpoint will accept (terminate) from the
Network (PSTN). The accept list may consist of multiple entries. The num-
bers are defined using the following wild cards:
Example:
963-8000 would be a specific incoming number that would be accepted by
this endpoint. If this endpoint consisted of a T1 with multiple DS0s, a
“hunt” group for 963-8000 would be formed. The entry $ would accept any
call.
S
EARCH
Write security: 3; Read security: 5
Defines to ATLAS 550 the order in which to search for an accept number.
P
RIMARY
S
EARCH
The S
EARCH
parameter instructs ATLAS 550 in which order to search for an
accept number match. Normally all searches are set to primary. The second-
ary search selection would be used to force ATLAS 550 to only accept a call
at this endpoint if all primary endpoints were unavailable.
For example, all long distance calls should go out a PRI directly to an IXC
(MCI, ATT, etc.), and local calls should go out a T1 to the LEC. It may be de-
sirable to place long distance calls on the local exchange if all of the IXC
trunks are unavailable (busy or in alarm). In this case, the primary accept
number for the local exchange would be N$, and the secondary accept
would be 1$.
X = Any digit 0 through 9
[1,3,5]=Any of these digits
0 = Default value
X = Any single digit
N = Any single digit 2 through 9
$ = Any number of digits of any value
9 =Thisspecificnumber
[1,2,3...] = A single digit in this group
Any specific entry will take precedence over a wild card. For
example, if endpoint A was designated as $ while endpoint B
accepted 963-800X, then an incoming call to 963-800X would
only be accepted by endpoint B.
