A SERVICE OF

logo

T1 ESF CSU ACE User Manual Chapter 3. Operation
61204025L1-1B © 2004 ADTRAN, Inc 43
Continue with standard operating procedures to edit the Network Interface parameters.
The fields and parameters available are as follows:
1)FORMAT
Sets the frame format for the NI. The factory default is ESF.
D4
ESF
2)CODE
Sets the line code for the NI. The factory default is B8ZS.
AMI
B8ZS
3)YEL ALRM
Enables and disables the transmission of yellow alarms. The factory default is ENABLED.
ENABLED
DISABLED
4)XMIT PRM
Enables and disables the transmitting of performance report messages (PRM) data on the facility data
link (FDL). The PRM data continues to be collected even if PRM is disabled. (Possible only with
ESF Format.) The factory default is OFF.
OFF
ON
5)KEEP ALIVE
Selects framed or unframed keep alive signal to be transmitted from NI when TI is in red alarm. The
factory default is UNFRAMED.
FRAMED
UNFRAMED
D4 is equivalent to superframe format (SF).