T1 ESF CSU ACE User Manual Chapter 3. Operation
61204025L1-1B © 2004 ADTRAN, Inc 47
Figure 3-17. Utility Menu Tree
1)SOFTWARE REV, Submenu of 3)UTIL
Use this submenu to display the current software revision level. This information is required when
requesting assistance from ADTRAN Customer Service or when updates are needed. The top line
gives the revision of interest. The bottom line displays information of use to ADTRAN only.
Follow standard operating procedures to access the 3)UTIL menu items.
2)REINIT UNIT, Submenu of 3)UTIL
Use this submenu to re-initialize the unit. This menu item does not restore factory default settings, but
simply resets the unit and causes it to run through its self test and initialization cycles.
3)ADDRESS, Submenu of 3)UTIL
Use this submenu to access the current Unit Address setting. Unit identification numbers must be
between 000 and 999. See Figure 3-18.
Figure 3-18. Re-initialize Unit/Address Screen
4)SET PASSCODE, Submenu of 3)UTIL
Use this submenu to access the passcode setting needed to control port access. The Unit Identification
number is limited to four digits between 0001 and 9999.
5)FACT RESTORE, Submenu of 3)UTIL
Use this submenu to restore factory default settings for all unit parameters. This restores all parameters
to the factory settings.
1)SOFTWARE REV (Displays current software rev.)
2)REINIT UNIT
3)UTIL 3)ADDRESS
4)SET PASSCODE
5)FACT RESTORE (Returns all configurations to
factory settings.)
6)REMOTE T-WATCH 1)ACCESS TYPE (Select remote unit type.)
2)SHELF SNMP ID:
3)SHELF SLOT:
