RackSwitch G8000 Application Guide
114
Chapter 7: Remote Monitoring BMD00041, November 2008
RMON group 1—Statistics
The switch supports collection of Ethernet statistics as outlined in the RMON statistics MIB,
in reference to etherStatsTable. You can configure RMON statistics on a per-port basis.
RMON statistics are sampled every second, and new data overwrites any old data on
a given port.
NOTE – You must configure RMON statistics for the port before you can view RMON
statistics.
Configuring RMON statistics
1. Enable RMON on a port.
2. Configure the RMON statistics on a port.
This configuration enables RMON statistics on port 1.
3. View RMON statistics for the port.
RS G8000 (config)# interface port 1
RS G8000 (config-if)# rmon enable
RS G8000 (config)# interface port 1
RS G8000 (config-if)# rmon collection-stats 1
RS G8000 (config-if)# rmon collection-stats owner “port 1 rmon”
RS G8000 (config)# show rmon statistics
RMON is enabled
Collection 1 on 7 is active, and owned by port 1 rmon
Monitors ifEntry.1.7 which has
Received 0 octets, 0 packets,
0 broadcast and 0 multicast packets,
0 undersized and 0 oversized packets,
0 fragments and 0 jabbers,
0 CRC alignment errors and 0 collisions.
# of packets received/transmitted of length (in octets):
64: 0, 65-127: 0, 128-255: 0,
256-511: 0, 512-1023: 0, 1024-1518: 0
