RackSwitch G8000 Application Guide
Chapter 4: Ports and Trunking
67BMD00041, November 2008
Port Trunking Example
In the example below, three ports are trunked between two switches.
Figure 4-1 Port Trunk Group Configuration Example
Prior to configuring each switch in the above example, you must connect to the appropriate
switch’s Command Line Interface (CLI) as the administrator.
NOTE – For details about accessing and using any of the menu commands described in this
example, see the Command Reference.
1. Follow these steps on the G8000:
(a) Define a trunk group.
(b) Verify the configuration.
Examine the resulting information. If any settings are incorrect, make appropriate changes.
RS G8000 (config)# portchannel 3 member 2,23,30
RS G8000 (config)# portchannel 3 enable
# show portchannel
Trunk 3: Ports 2, 23, and 30
Trunk 1: Ports 1, 7, and 32
30
23
2
1
7
32
