A SERVICE OF

logo

RackSwitch G8000 Application Guide
82
Chapter 5: Spanning Tree BMD00041, November 2008
RSTP configuration example
This section provides steps to configure Rapid Spanning Tree on the G8000, using the
Command-Line Interface (ISCLI).
Rapid Spanning Tree Protocol is the default setting on the G8000.
Configure Rapid Spanning Tree
Rapid Spanning Tree is the default Spanning Tree mode on the G8000.
1. Configure port and VLAN membership on the switch.
2. Set the Spanning Tree mode to Rapid Spanning Tree.
RS G8000 (config)# spanning-tree mode rstp