13.12
Removing and installing throttle rail
•
Remove fuel tank.
•
Remove left fairing side section.
•
Remove left-hand heat-insulating bulkhead.
•
Release fuel hose (1) at injection rail.
•
Release injection rail (2) at cylinder head and pull
out together with injectors.
•
Disconnect multiplug at throttle sensor.
L Note:
Only remove throttle sensor if it is to be replaced
(basic setting necessary).
•
Detach throttle cable (3).
•
Detach operating cable (4) for start speed in-
crease.
•
Release hose clips at the air intake lines, loosen
at the throttle coupling.
•
Remove throttle rail from stub pipe.
•
Pull air return pipe (5) off throttle rail.
•
Disconnect indicator lamp plug connection for
start speed increase.
•
Install in the reverse order of removal.
L Note:
Do not change the location of the hose clips on the
throttle coupling unions.
Firmly tighten hose clips at the air intake lines with
special tool, BMW No. 31 1 500.
LT130100
1
3
4
2
LT130110
5
