11.45
•
Press serrated washer (8) with eccentric shoul-
der into the chain guide rail spacing bushing by
a small amount.
•
Turn the serrated washer until the guide rail is
touching the outer edge of the cylinder head.
•
Press the serrated washer in fully and allow it to
engage at the two pins.
•
Secure the serrated washer with the small wash-
er and clip.
•
Remove the special tool.
•
Tighten the chain sprockets, holding the hexa-
gon on the camshaft to prevent it from turning.
X Tightening torque:
Chain sprocket............................................. 54 Nm
Checking valve clearances
•
Turn the engine over at the crankshaft (counter-
clockwise).
•
Measure valve clearance with feeler gauge.
Valve clearances:
Inlet.....................0.15…0.20 mm (0.006…0.008 in)
Exhaust...............0.25…0.30 mm (0.010…0.012 in)
•
If the valve clearance has to be corrected, re-
move the timing chain and camshaft again.
•
Renew the bucket tappets.
8
LT110680
