34.20
[ABS II] Removing and installing
relay and relay base
[ABS II] Removing relay
e Caution:
Switch off the ignition and disconnect and insulate
the earth (ground) lead.
•
Remove cover (1) from ABS control unit, press
the catch in with a screwdriver and pull the cover
off upwards.
•
Cover (1) must be scrapped.
•
Disconnect wires (2) and scrap the retaining
nuts.
e Caution:
Do not tilt the cables or the insulation may be dam-
aged.
•
Pull off the 2-pin plug.
•
Take out relay base (4).
•
Loosen the screws at the relay base by app. 2
turns with a Torx T20 screwdriver.
•
Pull the relay off upwards.
[ABS II] Installing relay
•
Insert ABS relay with FAG logo in the direction of
the retaining hook.
•
Tighten the screws at the relay base.
•
Push the relay base into the relay housing, at the
same time pressing both engine wires into the
left relay housing cable guide (red at bottom,
black at top).
•
Attach black cable to left threaded pin (M5) with
the crimp facing to the rear.
e Caution:
Do not tilt the cable or the insulation may be dam-
aged.
•
Push the 2-pin plug fully on in the correct posi-
tion and press the two wires into the centre
(smaller) cable guides.
•
Attach both connecting lead/wiring harness
plugs to the threaded pins with the crimp facing
forwards.
•
Press both leads into the remaining cable
guides.
•
Tighten the nuts.
e Caution:
Always use new self-locking nuts.
LT340270
1
3
2
4
