00.22
Installing cylinder head cover
•
Screw fitted bolt, BMW No. 11 1 980, (arrow)
into inner hole at the front.
•
Press centring pin, BMW No. 11 1 990, with
gripper, BMWNo.005500, into locating hole
under the third camshaft bearing.
•
Insert gasket into cylinder head cover.
L Note:
Begin installation at the crescents (1).
•
The marks (arrows) on the cover and gasket
must agree at the front and rear.
•
First press in the crescent at the rear (transmis-
sion end).
•
Lightly coat the gasket groove and the crescent
areas in the cover with oil to facilitate installation.
•
Apply a little 3-bond 1209 in the joint area at the
top and bottom chain case cover - cylinder head
(surfaces free of grease).
•
Fit cylinder head cover with gasket over the cen-
tring tools onto the cylinder head.
•
Screw in all retaining bolts such that they are still
not under preload.
•
Firmly tighten retaining bolts crosswise working
from the inside towards the outside.
•
Remove fitted bolt and centring pin, screw in last
retaining bolt and firmly tighten.
X Tightening torque:
Cylinder head cover to cylinder head ............ 9 Nm
11 1 980
LT000230
11 1990
LT000240
