Command Groups 105
Loopback Interface
Multicast
Command Description Mode*
interface loopback Enters the Interface Loopback configuration
mode.
GC
show interface loopback Displays information about configured
loopback interfaces.
PE
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 64.
Command Description Mode*
ip mcast boundary Adds an administrative scope multicast
boundary.
IC
ip mroute Creates a static multicast route for a source
range.
GC
ip multicast Sets the administrative mode of the IP
multicast forwarder in the router to active.
GC
ip multicast ttl-threshold Applies a
ttlvalue
to a routing interface. IC
ip pimsm Administratively enables PIM-SM multicast
routing mode on a particular router interface.
IC
ip pimsm bsr-border Prevents bootstrap router (BSR) messages from
being sent or received through an interface.
IC
ip pimsm bsr-candidate Configures the router to announce its
candidacy as a bootstrap router (BSR).
GC
ip pimsm dr-priority Sets the priority value for which a router is
elected as the designated router (DR).
IC
ip pimsm hello-interval Configures the PIM-SM Hello Interval for the
specified interface.
IC
ip pimsm join-prune-
interval
Configures the interface join/prune interval for
the PIM-SM router.
IC
ip pimsm register-threshold Configures the Register Threshold rate for the
RP router to switch to the shortest path.
GC
