A SERVICE OF

logo

414 LLDP Commands
lldp med confignotification
This command is used to enable sending the topology change notification.
Syntax Description
lldp med confignotification
no lldp med confignotification
Parameter Ranges
Not applicable
Command Mode
Interface (Ethernet) Configuration
Default Value
By default, notifications are disabled on all supported interfaces.
Usage Guidelines
No specific guidelines.
Example
console(config)#lldp med confignotification
lldp med faststartrepeatcount
This command is used to set the value of the fast start repeat count.
Syntax Description
lldp med faststartrepeatcount
count
no lldp med faststartrepeatcount
count
— Number of LLDPPDUs that are transmitted when the protocol is
enabled. (Range 1–10)