500 QoS Commands
The following table lists the parameters in the examples and gives a
description of each.
show policy-map
Use the show policy-map command in Privileged EXEC mode to display all
configuration information for the specified policy.
Syntax
show policy-map [
policyname
]
•
policyname
— Specifies the name of a valid existing DiffServ policy.
(Range: 1-31)
Parameter Description
Interface The port of the interface. If displaying the global
configuration, this output line is replaced with a
global configuration indication.
Intf Shaping Rate The maximum transmission bandwidth limit for
the interface as a whole. It is independent of any
per-queue maximum bandwidth values in effect
for the interface. This value is a configured value.
Queue Mgmt Type The queue depth management technique used for
all queues on this interface.
Queue An interface supports
n
queues numbered 0 to
(
n
-1).The specific
n
value is platform-dependent.
Internal egress queue of the interface; queues 0–6
are available.
Minimum Bandwidth The minimum transmission bandwidth guarantee
for the queue, expressed as a percentage. A value of
0 means bandwidth is not guaranteed and the
queue operates using best-effort. This value is a
configured value.
Scheduler Type Indicates whether this queue is scheduled for
transmission using a strict priority or a weighted
scheme. This value is a configured value.
