xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
501
Each command is listed, in detail, in the following sections.
config ospf router_id
Purpose Used to configure the OSPF router ID.
Syntax
config ospf router_id <ipaddr>
Description This command is used to configure the OSPF router ID.
Parameters
<ipaddr> − The IP address of the OSPF router.
Restrictions Only Administrator and Operator-level users can issue this command.
Usage example
To configure the OSPF router ID:
DGS-3627:admin# config ospf router_id 10.48.74.122
Command: config ospf router_id 10.48.74.122
Success.
enable ospf
Purpose Used to enable OSPF on the Switch.
Syntax
enable ospf
Description
This command, in combination with the disable ospf command below, is used to enable and
disable OSPF on the Switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
Usage example
To enable OSPF on the Switch:
DGS-3627:admin# enable ospf
Command: enable ospf
Success.
disable ospf
Purpose Used to disable OSPF on the Switch.
Syntax
disable ospf
Description
This command, in combination with the enable ospf command above, is used to enable and
disable OSPF on the Switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this command.
