xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
711
DGS-3627:admin# delete iproute 10.48.74.121/255.0.0.0 10.1.1.254
Command: delete iproute 10.48.74.121/8 10.1.1.254
Success.
show iproute
Purpose Used to display the switch’s current IP routing table.
Syntax
show iproute {[<network_address> | <ipaddr>]} {[static | rip | ospf | bgp | hardware]}
Description Use this command to display the switch’s IP routing table.
Parameters
network_address - Specify the destination network address of the route to be displayed.
ipaddr - Specify the destination IP address of the route to be displayed. The longest prefix
matched route will be displayed.
static - Specify to display only static routes. One static route may be active or inactive.
rip - Specify to display only RIP routes.
ospf - Specify to display only OSPF routes.
bgp - Specify to display only BGP routes.
hardware - Specify to display only the routes that have been written into the chip.
Restrictions None.
Example usage:
To display the contents of the IP routing table:
