A SERVICE OF

logo

MOBILE BASE INSTALLATION
Preparation
Version 1 Mobile Base Installation Guide
1-5
1c Remove the temperature sensor cable from the dyno.
1d Disconnect the input power cable from the Theta Controller.
1e Disconnect the brake power cable from the Theta Controller.
1f Remove the large rubber grommet from the hole in the dyno and remove
the brake power cable from the dyno.
Figure 1-4: Remove the Eddy Current Brake Cables
2 Remove the eddy current brake.
2a Remove the three bolts securing the couplers and set aside.
2b Remove the bolts and washers securing the connecting arms to the dyno
and set aside; there are four bolts securing each arm.
2c Slide the eddy current brake away from the dyno.
Figure 1-5: Remove the Eddy Current Brake
temp sensor
cable
brake power
cable
input power
cable
breakout board
large
grommet
theta controller
remove bolts (only one
visible from this view)
couplers
remove bolts
(only one visible from this view)