A SERVICE OF

logo

MOBILE BASE INSTALLATION
Installation
Version 1 Mobile Base Installation Guide
1-11
INSTALLING THE REAR WHEEL MOUNT ASSEMBLIES
1 Remove and discard the three existing bolts from the brake and the dyno; these
bolts are too short.
Figure 1-15: Remove the Existing Bolts
2 Secure one wheel mount to the dyno and one wheel mount to the brake using
three 3/8-16 x 1-inch bolts with thread lock and three 3/8-inch washers.
3 Secure each wheel mount to the mobile base frame using two 3/8-16 x 3/4-inch
bolts with thread lock and two 3/8-inch washers.
Figure 1-16: Install the Rear Wheel Mount Assemblies
existing bolts on brake
existing bolts on dyno
remove and discard
remove and discard
3/8 x 3/4-inch bolts
3/8 x 1-inch bolts
wheel mount
mobile base frame