Mobile Base Installation Guide
A-1
A PPENDIX
A
R
ED
H
EAD
A
NCHOR
I
NSTALLATION
This appendix contains instructions for installing the Red Head Multi-Set™II Anchors
used to secure ground hooks to concrete. The anchors and ground hooks will be used
to secure the mobile base dynamometer. To ensure safety and accuracy in the
procedures, perform the procedures as they are described. Be sure to read and
understand the warnings included in this appendix.
Refer to page 1-18 for instructions on installing the ground hooks.
WARNINGS
Always wear safety glasses and other necessary protective devices or apparel
when installing or working with anchors.
ITW Ramset/Red Head Multi-Set II Anchors are designed to operate properly
only when installed with ITW Ramset/Red Head brand Setting Tools.
The use of a 24 to 40 ounce hammer is recommended for expanding Multi-Set II
anchors.
The use of carbide drill bits manufactured with ANSI 894. 12-77 drill bit diameter
requirements is recommended for installation of this anchor.
Not recommended for use in lightweight masonry material such as block or brick.
Use of core drills is not recommended to drill holes for use with this anchor.
Not recommended for use in new concrete which has not had sufficient time to cure.
Anchor spacing and edge distance requirements (anchor installation locations) are
the responsibility of the engineer of record.
CONTACT INFORMATION FOR ITW RAMSET/RED HEAD
Contact ITW Ramset/Red Head at 1-630-350-0370, or 1300 North Michael Drive,
Wood Dale, IL 60191.
