A SERVICE OF

logo

Revision A 4-12-00 Document #98210104 3-1
Chapter 3
Installing the 224-4WD Dynamometer
Now that you have the Dyno unpacked, you may begin
the installation of the Dynamometer.
Track Placement
The dyno is designed to roll back and forth on the
track. The track must be anchored to the floor
using cement anchors.
Step 1
Lay out the track as shown in figure 1 (Appendix
A).
Step 2
Place the rail clamps over the rails before placing
the two end rail supports.
Rail
Rail Clamp