3 - 10 Document #98210104
Testing the Movement of the Dynos
Step 1
Connect the remaining wires to the Hardware
Stack as described in Chapter 2, page 2-5.
Step 2
Turn the Hardware Stack on.
Step 3
Press the red button on the Pendant, it should light
up, this indicates that the brakes are activated.
Cycle the brakes a few times by pressing the red
button to ensure that they work properly.
Step 3
While the brakes are on, press the “In” button on
the Control Pendant (pg. 3-22, letter E).
You should hear air venting,
and the the rail clamps releasing.
Keep holding the button down
until you see the motor shaft begin
to turn.
Repeat this procedure again,
only this time hold down the “Out”
button.
Note: The red button will control the brakes on
BOTH dynos.
Note: If the Control Pendant fails to activate
the motor, see the “Trouble Shooting
Guide” in Appendix A, Page 9.
